Il me fait de l'oeil aussi.
Et puis Shendrones quoi
Dans le genre de conceptions qui ont fait bouger les lignes. Et puis là, non seulement il est beau, mais il est développé avec la performance aérodynamique en tête. A quand les tests en soufflerie ?
Je me dis aussi que la canopy full doit bien protéger l'electronique. Des chocs. Et de notre rosée bretonne.
C'est clair que le Mifune, il s'utilise en automne et en hiver, même dans de l'air humide et de l'herbe mouillée
Je lorgnais sur le Tweaker que je trouve très réussi, mais on voit qu'en quelques mois Shen a fait évoluer ses frames à la perfection.
Ca avance, ils ont trouvé le bon matériau pour imprimer la canopy :
"Testing
So the test samples went out, and everyone loved it, saying it was fast and quiet. Then just about everyone cracked the canopy. Flo hit a PVC gate, Dane had a failsafe from altitude, Malte hit a gate then a tree, Chris hit a chainlink fence. All were big hits on hard surfaces, but it was becoming clear that this material, despite its beauty and stiffness, was just a tad too brittle.
Meanwhile, a customer, Josua Benner, told me about a nylon filament, Taulman 645, that's conventionally printed, almost as stiff, but with far greater elongation. I soon found out that a local flyer, Pixelrotor, prints Taulman 619 all the time, so I asked him for a couple samples.
The samples were just as advertised, slightly flexier than sintered nylon, way stiffer than TPU, and strong beyond belief. I bashed them with a hammer and didn't even leave a mark. Looks like this is the material.
Taulman 645 is tricky to print. It absorbs moisture so you have to dry it out before printing, and it runs just a tad too hot for the ptfc tubes in my Flexion extruders. I sent some to Chris Griffin of Phoenix 3d to test, and he was able to progress quite quickly from a tumbleweed-like blob to a nice Mako pod quite quickly. The bad news, however, is that Chris' fleet of perfectly tuned printers can't handle the size of the Mifune canopy, so he's currently ordering some printers to handle it."
Lu sur FB :
"Once we get some good prints it'll go up for presale."
Résumé : pour ceux qui pensaient à ce châssis, il ne devrait pas trop tarder
(mais pas pour la cb :s)
